12-07-2011 06:55 PM
I have a new CAT 3508 engine. The electronic control panel has an auto start function where the engine can be started remotely. I just got the schematic diagram from the local CAT representative. However, it's difficult for me to interpret the diagram and figure out the connections needed for auto start function.
Appreciate if some kind soul here would be able to give some pointers on how to connect the wiring.
Link to the schematic diagram --> http://www.mediafire.com/?qx368ar6cciwhyi
12-14-2011 08:01 PM
1.RENR7678 is schematic for 3508 Engine Electrical system.
2. There are optional equipments, and many devices are supplied by customer.
3. In G5 part, a double dashed black line show Remote STATR/STOP switch.
04-07-2012 06:55 PM
Hi, I have also problem with my cat but i do not have wiring diagram and i can not open Your link. Can You be so kind and send me thic electric diagram to my e-mail adress email@example.com. Thank You in advance for help.
04-26-2012 09:27 AM
Dear Sir, If you have the EMCP 3 or EMCP4, you need locate the drop down panel to the right hand if you stand looking at the control panel , on the terminal strip locate Di 2 , you will need to connect a volt free contact on your control, to run the negative(-) side of the 24 Volt D/C generator system. For example if it's on an ATS changeover when a power cut has been detected the phase failure relay will close contacts and complete the negative (-) side of the Generator D/C system and start the Generator when the yellow Auto mode button has been selected.